Mon-Fri: 7AM-7PM, Sat: 8AM-5PM Licensed & Insured [email protected] Serving all 50 states, DC & Puerto Rico
(555) 010-0000

Pre-Paint Washing for Brick in Your Area

Low-pressure wash for brick. Washing siding and trim before painting or staining so new paint bonds to a clean surface. Typical cost $250-$600.

Call (555) 010-0000Instant quote

From the free quote to the final rinse, pre-paint washing for brick in your area follows a simple process: inspect, protect, clean, rinse and check. For brick, that means low-pressure wash.

The right method for the job

Low-pressure washCleaning method
Usually 500-1,500 PSI with a wide fan tip, held well back from the mortarPressure

Cleaning solution: Soft wash for algae and mildew; a masonry-specific cleaner for efflorescence and mortar haze.

Caring for brick

Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit. Organic growth comes off with a soft wash; mineral deposits such as efflorescence need a masonry-safe cleaner instead of more pressure.

Avoid: Zero-degree tips and close-range blasting that erode mortar joints, and strong acids on brick that hasn't been pre-wet.

How often: Every 2-3 years for most homes.

When to book pre-paint washing for brick

  • You're about to paint or stain the house
  • Chalky residue comes off on your hand
  • Mildew or dirt under the old paint

Why it gets dirty

  • Paint chalking as it ages
  • Mildew that will grow through new paint if not killed
  • Dirt that weakens adhesion

What you can do yourself

  • Ask your painter what prep they need
  • Allow siding to dry for the time the paint maker recommends before painting

Not sure what you're looking at? The free stain identifier and safe pressure guide explain each stain and surface.

Common mistakes to avoid

  • Painting over mildew, which bleeds through
  • Too much pressure that damages wood or drives water into the wall
  • Painting before the wood is dry

What happens on the day

  1. Coordinate with your painter
  2. Protect plants and fixtures
  3. Kill mildew and wash the surface
  4. Remove loose chalk and dirt
  5. Leave the house to dry before painting

Pre-Paint Washing for Brick cost in your area

$250-$600Typical range for a typical home exterior
2-4 hours plus dry timeTypical time on site
Before every exterior paint jobRecommended frequency

What moves the price:

  • Size: square footage of siding, roof or flatwork
  • Condition: heavy growth, old stains and peeling finishes take longer
  • Access: number of stories, roof pitch, slopes and how close we can park
  • Add-ons: sealing, gutter brightening and other services done in the same trip

These are typical U.S. ranges, not a quote. You get an exact price before any work starts. For a quick estimate, try the pressure washing cost calculator.

Other services for brick

Local pre-paint washing for brick for your area

We provide pre-paint washing for brick across all 50 states, Washington, DC and Puerto Rico. Pick your state to see local details:

Pre-Paint Washing for Brick: frequently asked questions

How much does pre-paint washing for brick cost?

Pre-Paint Washing for Brick typically costs $250-$600 for a typical home exterior, and usually takes 2-4 hours plus dry time. The exact price depends on the size and condition, and you get it before any work starts. Call (555) 010-0000 for a free quote.

Do you use high pressure for pre-paint washing for brick?

For brick: usually 500-1,500 PSI with a wide fan tip, held well back from the mortar. What we avoid: zero-degree tips and close-range blasting that erode mortar joints, and strong acids on brick that hasn't been pre-wet. The cleaning solution does most of the work, followed by a gentle rinse.

Is pre-paint washing for brick safe for my plants and pets?

We pre-wet plants and lawns, keep cleaning solutions diluted to what the surface needs, and rinse landscaping again when we finish. Keep pets and children inside until surfaces are rinsed and dry.

How often should I schedule pre-paint washing for brick?

Every 2-3 years for most homes. Shade, nearby trees, humidity and heavy traffic mean more frequent cleaning; sunny, dry spots can go longer. Our free cleaning frequency tool gives a recommendation for your climate.

What if it rains on the day?

Light rain doesn't stop most washing, but heavy rain, high wind, lightning and freezing temperatures do. If the weather isn't right, we reschedule at no charge. Our work is backed by a satisfaction guarantee.

More services

Popular Exterior Cleaning Services in Your Area

Pressure Washing for Stamped Concrete

Moderate-pressure wash. Stamped and colored concrete is usually protected by a sealer.

Typical $150-$600

Rust Stain Removal for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $150-$500

Deck Cleaning for Cedar

Low-pressure wash. Cedar decks and fences turn silver-gray as the surface weathers.

Typical $250-$600

Sidewalk & Walkway Cleaning for Exposed Aggregate

Moderate-pressure wash. Exposed aggregate concrete has stones showing at the surface.

Typical $100-$250

Commercial Pressure Washing

Building washing and flatwork cleaning for offices, retail, restaurants, warehouses and other commercial properties, scheduled around your hours.

Typical $400-$2,000

Pressure Washing

High-pressure cleaning for driveways, walkways, patios, pool decks and other hard surfaces, with the pressure matched to each surface.

Typical $150-$600

Concrete Sealing

Concrete cleaning and sealing that helps resist stains, water and freeze-thaw damage on driveways, patios and stamped concrete.

Typical $400-$1,200

Paver Cleaning & Sealing for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $600-$1,800

Pressure Washing for Flagstone

Low-to-moderate pressure wash. Flagstone covers several stones, including sandstone, slate, bluestone and limestone, and they react differently to pressure and chemicals.

Typical $150-$600

Fence Cleaning for Cedar

Low-pressure wash. Cedar decks and fences turn silver-gray as the surface weathers.

Typical $200-$600

Pool Deck Cleaning for Stamped Concrete

Moderate-pressure wash. Stamped and colored concrete is usually protected by a sealer.

Typical $200-$500

Concrete Sealing for Exposed Aggregate

Moderate-pressure wash. Exposed aggregate concrete has stones showing at the surface.

Typical $400-$1,200

Ready for a cleaner home or business?

Get a free pressure washing quote near you. Tell us what needs cleaning and we'll give you a price and the next available date.

Call (555) 010-0000Book a visit
Call NowFree Quote