Mon-Fri: 7AM-7PM, Sat: 8AM-5PM Licensed & Insured [email protected] Serving all 50 states, DC & Puerto Rico
(555) 010-0000

Pressure Washing for Pavers in Your Area

Pressure wash with a surface cleaner for pavers. High-pressure cleaning for driveways, walkways, patios, pool decks and other hard surfaces, with the pressure matched to each surface. Typical cost $150-$600.

Call (555) 010-0000Instant quote

Grime, mildew and stains build up a little at a time until one day the outside of your property looks years older. Pressure Washing for Pavers in your area brings it back, usually in a single visit. On pavers, the method we use is pressure wash with a surface cleaner.

How we clean it

Pressure wash with a surface cleanerCleaning method
Usually 1,500-3,000 PSI with a surface cleaner, adjusted to keep joint sand in place where possiblePressure

Cleaning solution: A paver cleaner or pre-treatment; efflorescence needs a dedicated cleaner.

What to know about cleaning pavers

Cleaning concrete and brick pavers removes weeds, moss and stains, but some joint sand washes out with them. Re-sanding the joints, often with polymeric sand, and sealing afterward keeps weeds and ants out and holds the pavers in place.

Avoid: A narrow tip aimed into the joints, which blows out sand and can loosen pavers.

How often: Clean every 1-2 years; reseal every 2-4 years.

Signs you need pressure washing for pavers

  • Driveway or walkways look dark, gray or streaky
  • Green or black growth in shaded areas and along edges
  • Slippery surfaces after rain
  • Oil, rust or tire marks you can't scrub out
  • You're getting ready to sell, seal or paint

Where the grime comes from

  • Dirt and pollen that settle into the pores of concrete
  • Mold, mildew and algae in damp, shaded spots
  • Oil and fluid drips from vehicles
  • Rust from sprinklers, furniture and fertilizer
  • Tire marks and general foot traffic

Easy upkeep between cleanings

  • Sweep off leaves and loose debris so they don't stain
  • Blot fresh oil drips with cat litter or an absorbent right away
  • Point sprinklers away from walls and walkways to cut down on rust and hard-water stains
  • Rinse pollen off with a garden hose during heavy pollen season

Not sure what you're looking at? The free stain identifier and safe pressure guide explain each stain and surface.

What can go wrong with DIY pressure washing

  • Etched lines and 'zebra stripes' from holding a narrow tip too close
  • Water forced into window frames, door sills and siding laps
  • Damaged plants and lawns from chemical runoff
  • Injuries: a zero-degree tip can cut skin, and wet surfaces are slippery

What happens on the day

  1. Walk the property and note surfaces, stains and anything fragile
  2. Protect plants, outlets, lights and doors, and move small items
  3. Pre-treat organic growth and degrease oil spots
  4. Clean with the right pressure and a surface cleaner for even results
  5. Rinse, post-treat to slow regrowth, and walk the job with you

How much does pressure washing for pavers cost?

$150-$600Typical range for a typical home's driveway, walkways and patio
1-4 hoursTypical time on site
Once a year for most homesRecommended frequency

What moves the price:

  • Size: square footage of siding, roof or flatwork
  • Condition: heavy growth, old stains and peeling finishes take longer
  • Access: number of stories, roof pitch, slopes and how close we can park
  • Add-ons: sealing, gutter brightening and other services done in the same trip

These are typical U.S. ranges, not a quote. You get an exact price before any work starts. For a quick estimate, try the pressure washing cost calculator.

Other services for pavers

Pressure Washing for Pavers in your area

We provide pressure washing for pavers across all 50 states, Washington, DC and Puerto Rico. Pick your state to see local details:

Pressure Washing for Pavers: frequently asked questions

How much does pressure washing for pavers cost?

Pressure Washing for Pavers typically costs $150-$600 for a typical home's driveway, walkways and patio, and usually takes 1-4 hours. The exact price depends on the size and condition, and you get it before any work starts. Call (555) 010-0000 for a free quote.

Do you use high pressure for pressure washing for pavers?

For pavers: usually 1,500-3,000 PSI with a surface cleaner, adjusted to keep joint sand in place where possible. What we avoid: a narrow tip aimed into the joints, which blows out sand and can loosen pavers. We keep the pressure even and controlled, with the right tools for the surface.

Is pressure washing for pavers safe for my plants and pets?

We pre-wet plants and lawns, keep cleaning solutions diluted to what the surface needs, and rinse landscaping again when we finish. Keep pets and children inside until surfaces are rinsed and dry.

How often should I schedule pressure washing for pavers?

Clean every 1-2 years; reseal every 2-4 years. Shade, nearby trees, humidity and heavy traffic mean more frequent cleaning; sunny, dry spots can go longer. Our free cleaning frequency tool gives a recommendation for your climate.

What if it rains on the day?

Light rain doesn't stop most washing, but heavy rain, high wind, lightning and freezing temperatures do. If the weather isn't right, we reschedule at no charge. Our work is backed by a satisfaction guarantee.

More services

Popular Exterior Cleaning Services in Your Area

Rust Stain Removal for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $150-$500

Deck Cleaning for Cedar

Low-pressure wash. Cedar decks and fences turn silver-gray as the surface weathers.

Typical $250-$600

Sidewalk & Walkway Cleaning for Exposed Aggregate

Moderate-pressure wash. Exposed aggregate concrete has stones showing at the surface.

Typical $100-$250

Pre-Paint Washing for Wood Siding

Soft wash. Painted and stained wood siding grows mildew and loses its finish faster on the shaded and weather-facing sides.

Typical $250-$600

Commercial Pressure Washing

Building washing and flatwork cleaning for offices, retail, restaurants, warehouses and other commercial properties, scheduled around your hours.

Typical $400-$2,000

Concrete Sealing

Concrete cleaning and sealing that helps resist stains, water and freeze-thaw damage on driveways, patios and stamped concrete.

Typical $400-$1,200

Paver Cleaning & Sealing for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $600-$1,800

Fence Cleaning for Cedar

Low-pressure wash. Cedar decks and fences turn silver-gray as the surface weathers.

Typical $200-$600

Pool Deck Cleaning for Stamped Concrete

Moderate-pressure wash. Stamped and colored concrete is usually protected by a sealer.

Typical $200-$500

Concrete Sealing for Exposed Aggregate

Moderate-pressure wash. Exposed aggregate concrete has stones showing at the surface.

Typical $400-$1,200

House Washing for Log Homes

Low-pressure wash. Log homes need regular cleaning to keep mildew and insects from settling into checks and cracks, and the logs must be clean and dry before a new stain goes on.

Typical $300-$700

Pre-Paint Washing

Washing siding and trim before painting or staining so new paint bonds to a clean surface.

Typical $250-$600

Ready for a cleaner home or business?

Get a free pressure washing quote near you. Tell us what needs cleaning and we'll give you a price and the next available date.

Call (555) 010-0000Book a visit
Call NowFree Quote